← Related research
CAN / ECU Testing
Automate CAN-based ECU testing without losing the engineer in the loop
A CAN or ECU test procedure is never just "send a frame." It is acquire the interface, send only the approved message, watch the gateway or ECU response, capture evidence, and release the bus cleanly. Every one of those steps is usually done by hand, on a laptop, by whoever is free that day.
Release-gate CAN captureExample run
- Commanded pressure
- 38.2 bar
- Measured pressure
- 37.9 bar
- Gateway dropouts
- 0
- Decision
- release evidence ready
The workflow today
- Attach the adapter and bring the bus up manually before every run
- Hand-craft or replay raw frames from a DBC, one test at a time
- Watch signals in a scope tool and decide pass/fail by eye
- Write up what happened afterward, from memory or screenshots
With Plotune Nexus
- Acquire the CAN interface as a bounded operation, released when the run ends
- Encode and send only the approved message from your DBC, at the required cycle time
- Gate the next step on a decoded signal condition instead of a fixed wait
- Package the run as one reviewable artifact: trace, decoded signals, and verdict together
Supported integrations
Classic CAN
CAN FD (SocketCAN)
DBC decode / encode
XCP-on-CAN
UDS over CAN / DoIP
See this mapped to your bench.
Plotune Nexus is one product, this is how it runs against CAN / ECU Testing.